Microplex M204 Especificações descarregar pdf (Página 91)

USING THE M204’S COMMAND SET: npsh Basic Commands 83

list tcpip > prn1

sends current network settings to the ﬁrst parallel port.

chr $FF > prn1

sends a formfeed to PRN1.

npsh Basic Commands

Before reading on about the M204’s command set, it is important to understand some

of the basic commands involved.

Set commands affect only current settings, not stored settings in EEPROM. The save

command is used after set to save the new settings to EEPROM.

Store commands only affect stored settings in EEPROM but not the current settings.

This means the M204 must be reset to make any changes take effect. For example, if

you change the current settings of the IP address and the netmask, this will only take

effect after a reset (warm boot) from EEPROM, or after a power-on (cold boot).

npsh Command Set

Command Syntax

The commands in this section are listed alphabetically by title and include all com-

mands available on the M204.

The command syntax follows the command name, where:

• Arguments enclosed by brackets [ ] are optional.

• Arguments in bold italics are user-deﬁned strings.

• Arguments separated by the or symbol ( | ) mean that a choice must be made.

An explanation of what the command does and how to use it follows the syntax. All

examples for a particular command are provided at the end of that command’s main

section and when another command or other information may be useful, a reference is

given.

Examp

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 203 204

Sem comentários

Microplex M204 Especificações Página 91