Microplex M204 Especificações descarregar pdf (Página 88)

80 M204 INTERNAL ARCHITECTURE: Logpaths

unit

host

Logpaths

The term logpath comes from the UNIX syslog logging system. With the M204, each

destination can report statistics on: user, page count, job name, and printer errors. In

addition, a checksum calculation can be obtained to conﬁrm data integrity when a job

is sent to the printer.

Logging occurs either through a printer or terminal connected to an I/O port, or

through a Telnet session to a particular TCP port. A logpath can also be conﬁgured to

report statistics via email to a particular user. This can then be saved to a ﬁle if desired.

In addition, messages can be logged to SYSLOGD on a particular TCP/IP host.

Each logpath is associated with a particular destination and the eight default logpath

names range from l1 to l8. Logpath names can be changed to be something more

meaningful.

Logpath deﬁnitions include: name, log port, and log type.

See also: list logpath on page 87, set logpath on page 95, and Capturing Printer Feed-

back on page 122, and USING NPWIN on page 113.

I/O Ports

The M204 comes with four I/O ports: two IEEE 1284-I compliant parallel ports and

two serial ports. These ports have several parameters such as ﬂow control and baud

rate, that can be manipulated to best suit your attached peripherals. These parameters

are conﬁgured using the set commands while list commands display each port’s set-

tings. Please refer to the following commands for the indicated information:

• To learn more about the I/O port parameters, please see:

Connecting Peripherals on page 17.

• To look at current I/O port settings, please see:

list com1|com2 on page 85 and list prn1|prn2 on page 87.

• To change I/O port settings, please see:

set com1|com2 on page 92 and set prn1|prn2 on page 99.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 203 204

Sem comentários

Microplex M204 Especificações Página 88