Microplex M204 Manual descarregar pdf (Página 9)

05/13/97 9

M204 v5.7.2 Release Notes (Con’t)

slowmode Speed. Slow the data transfer rate.

vslowmode Speed. Slow the data transfer rate even further to

accomodate slower or older printer models.

With version 5.7 and higher, this command has been changed to:

set

portname

mode slow|cen|pc|fast|bb

where:

portname “

prn1” or “prn2” for the parallel ports.

slow Slow the data transfer rate.

cen Centronics mode. Use with

older impact printers

(i.e. dot matrix, line printers).

pc Default mode. Will work with most printers.

fast Increase the data transfer rate. Used with some

newer, faster printers like the HP 4 and 5 series.

bb Bit Bucket mode. Simulate an attached printer even

if one isn’t attached.

There is

no longer a setting to adjust the ﬂow control method of the paral-

lel ports from busy mode to ACK mode. This is no longer necessary.

Using the

old command syntax for the parallel port will continue to work

with version 5.7 but this will eventually be phased out in future ﬁrmware

releases.

The following commands have been added to the “npsh” command shell:

store ifc wvln nwid

networkid

This command assigns a particular networkid (in the range of 0100 -

FFFF hexadecimal) to the M204’s connected WaveLAN card. Both the

network ID and the frequency must be the same between any device the

M204 tries to communicate with using the wireless network.

set sysinfo module [-]novell [-]appletalk [-]netbios

Prior to version 5.7.2, only the Novell and AppleTalk stack could be

enabled or disabled within the M204 allowing for easier memory alloca-

tion or network broadcast control. However, with version 5.7.2, the Net-

BIOS over TCP/IP protocol can now be controlled as well.

store tcpip tcp opts [-]disbufmgmt

Use this command to enable or disable receive buffer management on the

M204. The receive buffer controls how many simultaneous TCP connec-

tions can be allowed with the unit at one time. The only time you may

need to have receive buffer management turned off is if you notice short

pauses between the end of one print job and the start of the next job usu-

ally with LPR printing.

New

Note

New Commands

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

Microplex M204 Manual Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Microplex M204