Microplex M204 Manual descarregar pdf (Página 10)

05/13/97 10

M204 v5.7.2 Release Notes (Con’t)

store pserver opts [jobtimeout

seconds

]

This command only applies if a logpath setting is used for printer feed-

back (e.g. logpath type equals “printer” for printer errors). Adjusting this

seconds value will tell the print server how long to wait for printer feed-

back at the end of a print job before it continues on to the next print job in

the queue. The default value is 0 meaning it will hold indeﬁnitely. Most

printers should respond quite quickly so you won’t need to adjust this

value but if you have time-critical printing happening (e.g. one job every

7 seconds) with certain logging requirements, this may come into play.

Anytime you execute a “

store” command, you must reboot the print

server with a “reset” command or physically unplug and plug it back in.

Otherwise, the setting will not become a current or working setting in

memory.

NOTE: If you are experiencing any conﬁguration problems with the M204, you might want to

look at the “Microplex Training Guide for All Products” found under the Technical

Support section, the “Support Shack”, at Microplex’s Web site (www.microplex.com).

Note

1 2 3 4 5 6 7 8 9 10

Sem comentários

Microplex M204 Manual Página 10